Double Morse Taper Mandrel

[Spindle]

Hi

I notice people were looking for these and the nearest they appear to have got was engineering lathe set up bars, (a morse taper one end and a centre at the other end of a parallel section).

Whilst looking for something else I found this on the Record Power site:

http://www.recordpower.co.uk/product/16 ... /4#reviews

Hope this helps those who are searching

Regards Mick

 

[KimG]

The link goes to a page with the 1624 lathe on it Mick, nothing about a mandrel there I could see, did you get the link right, did I miss something?

 

[Phil Pascoe]

It's right under the lathe.

 

[CHJ]

It's right under the lathe.

No it isn't, the images displayed are dependent upon previously viewed items as targeted by cookies/browsing history/associated items being promoted.


http://www.recordpower.co.uk/product/2- ... ent-centre

 

[monkeybiter]

http://www.recordpower.co.uk/search/q/2MTNA

 

[Phil Pascoe]

Sorry, C. - it was under the lathe when I first looked for it.

 

[Phil Pascoe]

There doesn't seem to be any 1mt's out there - I wonder why?

 

[jpt]

Mark Raby does a good system which I use myself and it is cheaper than the Record one and is available in bot 1 & 2 mt.

His website is http://www.markrabywoodfinishing.co.uk/ but they are not shown on there so it is worth dropping him an email.

john

 

[Tazmaniandevil]

I turned one from iroko for my Record Power lathe. It's just fine for alignment of the centres.