Bodrighy
Established Member
This is cherry, 4" dia, 2 1/2" tall with a 2" opening. It started off with a 1/2" hole but I went too thin at the 2" mark and had to cut the centre out.
It's about 1 - 2mm thick. Inside is smooth but I had trouble eradicating tool marks. Couldn't get a gouge into the hollow and was using a small swan neck thingy. Any advice on getting it really smooth would be welcome.
Thinking of making a lid with finial for it.
Pete
It's about 1 - 2mm thick. Inside is smooth but I had trouble eradicating tool marks. Couldn't get a gouge into the hollow and was using a small swan neck thingy. Any advice on getting it really smooth would be welcome.
![](https://proxy.imagearchive.com/aee/aeed57028b6312561bb771c2368564b9.jpg)
![](https://proxy.imagearchive.com/3ab/3ab6947cbd9726e1d9e9ea14a65a26b9.jpg)
Thinking of making a lid with finial for it.
Pete