Cable routing

[mailee]

As I am moving into my new shop I wondered about routing the supply cables to my big machines? Mainly I am thinking about the table saw and how to place the cable to it? As the roof is 18' high dropping a cable to it seems out of the question. What do you guys do with your own installation or have you any ideas on the subject? :?

 

[twothumbs]

Depends on width of shop but how about a taut suspension wire on which you can hang your looped supply cable as long as you dont dunt it with lengths of wood. Possibly better than a cable sleeve on the floor as a trip hazard. You would need a vertical pole ala supermarket style. Good luck....and Christmas.

 

[No skills]

Cable tray hung from steel studding then cable tie your feed wires to that.