Search results

I have an outdoor project in mind that I would like to make from green oak 3" x 3", with a minimum length of about 6ft. Calling around timber yards in Essex and I find very few, so far one supplier had 4" which should be cut down but they were £45 for 6ft, the other was cheaper but they would...

Im wondering if anyone knows of a generic motor or alternative supplier for Clarke parts, I contacted Clarke spares and the following replacement motor part is almost as expensive as the sander was new. Part# UT821587 MOTORc/wRELAY CS4-6C ITEM 39 For an extra £20 I could...

Ive been giving my SIP 12" bandsaw a bit of a service recently. Replaced most of the blade guide bearings as they were mostly sized and then found the main wheel rear bearing was also seized. I've ordered replacements (6203 ZZ) and have removed the old bearing in preperation however i wondered...

Im looking at buying a dust extractor for my 12" bandsaw as Im fed up with sweeping up saw dust. Im looking at either the Record RSDE1 or RSDE2-A - Id prefer the later but my question is will either of these maching work OK if they are mounted on the wall above the bandsaw - about 6-7ft up...

Can anyone recommend where I can get featherboards that fit into 9.2mm and 12.5mm tracks? Seems that everyone else does 1/4" and 5/8" or magnet - which I dont feel very trusting of.

Hi, does anyone have a Dakota Precision Scroll Chuck Kit - theyre on offer from Rutlands at the moment and seem a good deal. The question I have is are they self centering - and Im assuming that means that there is just one place to tighten all 4 jaws at the same time...

So after the lack of sucess with my bowl I thought I'd go back to pen making for a while. I picked up some Burr Horse Chestnut, turned the pen blanks but found there were lots of holes in the wood which meant that you can see the brass inner tube. Is there a trick to fill these holes or is...

Hi, Im fairly new to turning, so far Ive turned about 12 pens and a few coasters, mallet, dishes and a hoover handle (dont ask!). I started turning my first proper 10" oak bowl and Im finding that the bowls slightly oval and not round, and so far Ive not figured out how to correct or...