Search results

HI ALL im going to be making a couple of bedside cabinets in mdf finishing with a painted white gloss paint will it be sufficient to just seal the edges with mdf sealer proir to painting regards les

HI ALL can anyone help i have a black and decker planer thicknesser attatchment (which is the same as a dewalt de8000) and i am trying to find out what b&d planer fitted best regards les

HI ALL im trying to purchase a proxxon ft 300 router table but it has been discontinued if anyone has one that they wold consider parting wih could they please contact me best regards les

HI ALL dont know much about plywood what is the best grade to get as there seems to be a lot of difference ive only been looking in b&q etc is there anything better regards les

hi all just finished reading an article on how to mark out dovetail joints this always seems to be skipped over and hardly mentioned in all the articles and videos i have seen but this was (to me ) first class perhaps any of the experts out there might like to add comments please excuse me if...

thanks very much for the replies as soon as you see it written down it all comes back thanks again regards les

HI havnt used my maths for some time how do you calculate cubic mm into cubic meters then cost it ie 50mm x 50mm x 500mm is 1250000 cubic mm then what for eq timber @ £100 per cubic meter i want to be able to do this on paper so i dont have to keep on getting the computer out but all i can...

hi all does anyone know of a supplier ( hampshire surrey or sussex )who will supply small pieces of veneered mdf i can only find suppliers of full sheets apart from the cost its also transport storage etc (i have only a small workshop regards les

hi does anyone know of any books on antique furniture that shows dimensions and method of construction (ie various joints used ) regards les

hi does anyone kow where i can get a left handed tape measure from axminster no longer lists them regards les

hi all having limited space i always find it awkward cutting sheet material i was thinking about makng a frame similar to a panel saw and screwing this to the workshop wall to support the sheet vertically then cutting with jig or circular saw has anyone tried this or have any other suggestions...

HI ALL this has proberbly been asked before but what should one do as some fillers (mahogany) when sanded is a lot lighter than the actual timber regads les

HI ALL im new to this forum and need some advice on radial arm saws how safe is a dewalt when rip cutting my only (bad ) experience f using a radial arm saw was when a piece of ply i was cutting kicked back after extracting alot of ply from my fingers i got rid of it but i have recently been...