Search results

l’m very happy with my Axminster AC216TS.

PM sent re the surface clamp.

PM sent...

But there are some mouth watering deals on opal fruits...

PM sent...

Darn. I was going to join the zoom call, but it completely slipped my mind.

Here’s a little oak end table that I finished recently.

I am a fairly new woodworker and I find that using handplanes is one of the most satisfying aspects of the craft. In my view, the most important aspect of hand tools is knowing how to sharpen. A keen edge makes all the difference. There's plenty of information out on the inter-web-net thing...

Something like this perhaps? I made this with 12mm ply and 18mm MDF for the top.

I’d agree with this. I had the Record Power BS250 which is a lovely machine. However it didn’t take long for my ambitions to outgrow its capability.

I use a similar setup for home brewing. i have a fridge with a greenhouse heater in the bottom. The temperature is controlled with an Inkbird controller which has two switched power outlets and a temperature sensor, one to switch the fridge on/off and the other to control the heater. You just...

I think it’s exactly what happened. It’s so easily done if you aren’t paying attention and not using anything to hold the work down.

One of my neighbours had a nasty accident with his circular saw a week or so ago. He was ripping some thin pieces of timber to make a trellis to save spending £18 on buying something. He ended up taking the tops off three fingers(index, middle and ring). Apparently, the finger tips were...

Agreed - I have soem Clarke clamps from Machine Mart and they are awful.

I have 4 x 600mm Axminster parallel clamps and 6 x 900mm clamps from Rutlands. Apart from the colours (and length obviously :) ) they look identical. I suspect they were made in the same factory. As far as performance is concerned, they are very good.

I have had no issues at all with Axminster's customer service. As far as badging chinese-manufactured machines, it's no different to Record Power, Charnwood etc. The planer-thicknessers are all pretty much identical save for some minor details. The same applies to bandsaws. I have the Record...

i have just bought the Axminster AC250PT. So far, all I have done is checked it for alignment and run a board over the planer to check it out. It did an excellent job. My first choice would have been the Record Power PT107 but they aren't going to be available until June. The AC250PT was my...

Here’s a review of the Charnwood planer thicknesser.

I have no complaints about them. The delivery driver was a really nice chap, very helpful and interested in what I was going to use the kit for. I think a lot or most of the criticism is unjustified.

I started with a Record BS250 and whilst it's an excellent machine, it didn't take me very long to out grow it, so do take heed of @TRITON 's advice :) . Like @moosepig I now have a Record Sabre 350 which is a lot of bandsaw for the money.