Search results

Thanks. It should not affect the angle accuracy anyway. It still goes back to starrett because of the square head

Thats what I thought, thanks. How about the protractor head? Is that OK or should be flush?

Hi Guys. I believe that I have a problem with my square head. I wonder this is an error within tolerance of is it too much. I bought my Starrett C435M-300 few months ago but I did not need to use the square head separately until few days ago. I used it for the project to measure 90 degrees. The...

Hi everyone I have a similar situation to Sam's. My table saw dust extraction port is 100mm but my cyclone has only 50mm inlet and outlet to the shop vac. I am not considering at the moment upgrading the cyclone but I want to make a little more substantial dust extraction system. I know that...

thanks guys. I decided to go for axi ts250. Iron cast and induction motor are very tempting :)

Thanks, that helps a lot I think I will go for ts250, especially that guy selling on ebay k419 is not replying ;)

Sorry, I meant kity 419 of course

I have an opportunity to buy a second hand kity 619. My only worry is that it could be underpowered. How does 1.1kW motor cope with hardwood? I do not have a space for large table saw so I am considering Kity or Axminster ts250 which has 1.5kW motor but probably not as good build quality as...

yes, I mean site jobs :) I am not expecting ready product straight out of the saw, I just want true , square cuts which I do not always get with my dewalt. Thanks, that give me some idea about bosch. How did you like the fence? I have heard that it may be some play. I must admit that dw745 fence...

Thanks. Do you use it for side jobs or you are do more fine woodworking?

Hi All I heed an advice from owners of Bosch GTS J10 XC. I have Dewalt DW745 and near the blade the table is off by 0.04”. I am aware that both saws are contractor saws and don’t expect miracles but 0.04” is a bit too much. I would expect the quality of the table in Bosch to be higher as the...

Thanks, I may go for that, need to do some research

I guess it is some idea but I would have problem with when fence

thanks everyone, maybe I do I expect to much from site saw. I would not say I have a high spot, it's more like top is sagging it the middle around the blade. I would have to grind/sand 80% of the top surface to match the low spot, Im not sure how achievable that is

Hi everyone. Please advise. I own DW745 table saw which is out of flat near the insert plate by 0.02" comparing to the edge. It does effect my cuts and to get perfect 90 degrees I need to adjust the blade angle almost every time when I change a rip width. Dewalt do not give me an answer what...