Search results

Axminster m950 Few years old now (not white but blue) but does the job as well as its always done. Belt and cones adjusted recently and little use since. All the spec is on the Axminste site. I will also be selling a radial arm saw ( older type) and a 50ltr compressor in the near future...

-------------------------------------------------------------------------------- From the list of boards I have left..... Fiddle back sycamore 11/2"x 9" x 10ft " x 8" x " Sycamore 11/2" x71/2" x 10ft " x 7" x " Plus sweet chestnut as list and 3" sycamore. Not far from Yandles if your...

From the list of boards I have left..... Fiddle back sycamore 11/2"x 9" x 10ft " x 8" x " Sycamore 11/2" x71/2" x 10ft " x 7" x " Plus sweet chestnut as list and 3" sycamore. Not far from Yandles if your going to the show come take a look. Martyn

https://www.ukworkshop.co.uk/forums/view ... hp?t=35052

Had quite a response to this but as yet all is still available.. Please remember that this is air dried sawn timber from forestry work. Some boards are stained, a little rotted on the edges here and there and one or 2 of the wide boards have split. This is due to the environment in which the...

https://www.ukworkshop.co.uk/forums/view ... hp?t=34991

I have had a change of direction so excess timber is now being sold. This is mostly 2/3 years air dried stacked in my barn where the ends were sealed and the stack stickered. Most comes in 12ft lengths of various widths and thicknesses from inch and a half up to 3inch, with one sycamore board at...

After a house move and probs with the bt line its good to be back on line after nearly 3 weeks. Now in a farm house near Taunton with a log burner I thought it only right that we should invest in a chainsaw :D . Our Countrywide store has a 10% off deal on Stihl chainsaws so off to take a gander...

Not usually over this side but I can be found on the wood turning section. I need some advice........... I am making a couple of windsor smokers bow chairs and was just wondering what you guys would recommend for curving the seat. I know traditionaly an adze and traverser is used but can I get...

If you read my recent workshop pics thread then you will know that although I have been on here a while I have only just had the time to get pics on. Heres a sycamore lamp I did a few years back. I chose syc as its rather plain but shows detail well. By the side is a small goblet turned from a...

Hope this is going to go ok, never used photobucket before...... Any way heres a couple of pics of our set up.... The lathes are at the far end behind my daughter. One on the left is the record no3 with a router box on it and the one on the right is the Axminster. Will get some better lathe...

Does any one on here have a legacy and if so what do they think of it ? Does it do all that the makers claim? What are the bad points? Is it a usefull tool or something you use twice then wish you had'nt bothered?

Hi all, I can't find a search topic on here. I am looking for any information on steam bending. I plan on using a wall paper stripper to supply the steam but i have never done it so any help would be appreciated. Chair components being the main use.

Hi all i am new to this forum so forgive me if there is already a thread covering this somewhere. I need to source some good plans for english period furniture. At the moment in particular wardrobes but later fourposter beds, chests blanket boxes etc.Does any one know a good source for these? I...