That's cheap. I used 3Dprint-uk before and I think the minimum order worked out about £40 including postage.
Will bookmark these for next time, thanks.
Had an idea which works close enough - put a 5mm packer between the blade and the blade holder. Wasn't so hard. :wink:
Total dim of 36.5 less 31.2 blade (originals were 32.5). They are just about 0.3mm smaller than before but I don't think this will make much difference on this planer. The bed...
Yes unfortunately there is no way to fine adjust the blades once they are on the spindle. They get set in position when they are attached to the blade holders. These are then bolted to the spindle (the last set of bolts are non-adjustable).
If I can't get hold of a setting jig I will have to try...
Good morning. The blades on the thicknesser are shot (full of nail dings) so I went to drop in the new ones I have had waiting. I did not know I needed a setting jig (small bit of plastic) and cannot find it anywhere. The spare parts service are out of stock and I am now left hanging. Have taken...
Hi Roger, (I'm also a Roger)
Will watch this with interest as like you I have been making windows from iroko. In my case it is the reclaimed stuff ex school chemistry labs. The stuff I have is mostly a bit darker. I've finished it internally in tung oil, but ended up running out of time in...