Recent content by seeall

Thank you for responding, rogxwhit, it is most appreciated. Not to worry, I will do as you suggest and work from scratch. Luckily the adjustment screw came with the sawbench. I am considering making the adjuster out of a piece of scrap brass I have to hand. Do any drawbacks come to mind with...

Good afternoon, I also own a TA 255, sadly without the fine adjustment bracket. You mention that you made yours, do you have any dimensional drawings you drew to work from when making the adjuster? If possible, I'd be interested in a copy of the drawings. I look forward to hearing from you...

Thank you for your response. This is a different machine to the last one I asked about a handbook for last time. That machine was completely overhauled, refurbished and sold on. The differences between this machine and the other two Sedgwick planer/thicknesser machins I've refurbished are...

following on from my request yesterday, I've carried-out a further inspection of the machine. It's a 3PH model, the power feed is via a single speed reduction gearbox attached to the 0.5HP motor. The following letters and numbers are stamped into the infeed table rebate: MB V 612. I hope...

Hi, I've found a Sedgwick planer/thicknesser machines in a garden, this afternoon. Apart from surface rust the machine appears to be in 'good condition.' I've managed to take a few measurements, etc., from which I hope you will be able to identify the model number. Colour Green Height to top...

Hi, do you have a manual for the Sedgwick MB 12" Planer/Thicknesser, which you can e-mail to me? I've recently moved house, and found the machine in one of the outbuildings, obviously it requires refurbishing. Any help will be appreciated, photos, set-up, etc. Best wishes, Jeff

Hi, I've been given a Multico M3 Morticer which has been stood in a workshop unused for a number of years. Hence it is covered with surface rust, but with no obvious faults or pit marks. My winter project is to overhaul the machine, but, before starting the process, I'm looking for a Manual...

Hi, I've been given a Sedgwick MB310 Planer/Thicknesser which has been stood in a workshop unused for a number of years. Hence it is covered with surface rust, but with no obvious faults or pit marks. My winter project is to overhaul the machine, but, before starting the process, I'm looking...

Hi, I recently purchased a 52ins. x 10ins. jointer/ planer made by Watts Bros. (Sheffield) Ltd. This is substantial cast iron machine, complete, except for the motor. The planer top section is bolted to a lower cast iron base - 34ins. overall height. The infeed (10 3/4ins.) and outfeed (9...