You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser.
Help Support UKworkshop.co.uk:
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
-
-
R
@jack.in.the.woods there is a thread on here where one of the moderators pimped his RP 300/350
check it out as it might help.
-
R
Cast iron will seem hard, but you can drill it with no problem. It it is self lubricating on your drill bit due to the free carbon in...
-
R
I have an old lamp post which I think is cast iron and would like to mount a CCTV on it and would like to know if I can drill into the...
-
R
I started redwood pine ones with par 9 by 1. Maybe 6 or 7m. Preferably 22mm sometimes 8 by 1 as it gives less sapwood. Don't use spruce...
-
R
@johnnyb Assuming you use 6x1 timber, how many metres does it take to make a chair
-
R
@Cordy how much timber do you use towards a single Adirondack and what size do you normally opt for?
I have just made up the templates...
-
Loading…
-
Loading…