Recent content by Roskrow

I have just bought a DRO kit from Warco. But although they provide instrucions I am nervous to try is there anyone in the Bristol Area who can help me. I live in Easton-in-Gordano. In anticipation..Thank you Roskrow

There seems to be a lot of NOT very good Lathe tools available, can anyone direct me as where to get the BEST.I make Steam engines, which calls for a lot of small detail. Any assistance very much apreciated

I am about to purchase a new table saw. My thinking is down to either the Charnwood 650 or the Record TS250. I have been given conflicting views as to which is the better. Way back Record used to make great tools, but all I have seen recently is that their standards have dropped. Anyone out...

I too endorse everything good said about Roger I have jsut had delivery of an Incra 1000 HD. His knowledge, help, and speed of service is 100% good. I think I will now get the Incra Rule and Protractor. Not cheap, but willl make marking a doddle. Any Comments ?

Thank you both for your replies. I will see if I can now get it right!!

I know this is a topic that has been much discussed. At present I have a Ryobi EMS1526AL. But the Guides are too narrow to use either the Kreg, or Incra system. The current Balde is 254mm. I need to be able to cut repeated cuts at specific angle ( do segmented wood turning). I have a chop saw...