Recent content by pewe

This is a very old thread but I came across it whilst searching for a solution when my 1998 Bosch GOF 1300 router, after may years of reliability, started blowing mains fuses whenever I turned it on. After reading the comments here I removed the suppressor which stopped the problem, meaning that...

It is - but it will be going to the scrap yard if no one is able to collect by the 14th Dec. It is in storage near Hinckley Point, North Somerset.

I have a Sliding table available for free to anyone who wants to collect it. We are in North Somerset - Near Hinckley Point power station. The table will also fit other saws I believe. No Longer Available.

Thanks guys. Ok, the white bloom has now all gone - the large 'spill' areas were solved by using meths and the 'rings' were removed using a hair dryer. The only problem I have now is that the lacquer's shine has been dulled by the meths so I need to get the shine back. I tried using wax, but...

I tried vigorous buffing and it didn't fully revitalise the sheen - but I will address the rest of the watermarks then try again. If still not satisfied I'll try some wax - not too bothered about re-applying periodically as we re-oil the worktops in the same room regularly anyway. Thanks for...

I have now tried rubbing a damaged area with meths - which has improved it dramatically BUT the shine on the lacquer has been dulled by the meths - seen in the image in front and to the left of the chair cushion. Other than spraying the whole top with a new coat of lacquer, are there any...

Tried that - maybe I put too much meths on :shock: Seriously though, thanks for the tip - I may try that as a last resort.

Thanks for the info and link guys. Unfortunately I tried both the Mayo and Vaseline, leaving them overnight, and neither seem to have improved the marks. So will need to try some of the other methods shown in the link. If I have to resort to re-lacquering, any suggestions or recommendations...

It is definitely lacquered - I spoke to the supplier this afternoon and they confirmed it. They said they had a customer who had had a similar problem with the same furniture last year - and it cost him £200 to have it professionally dealt with. Unfortunately we don't have any Mayo in the house...

I need some advice regarding a lacquered Oak table which has been damaged by water. The white marks were 'hidden' under a 'protector' under the table cloth so we've only just noticed the damage. Anyone any advice on how we can rectify the problem - or is it a complete (expensive) strip and...

Possibly, but there may be other solutions. I'll have a better idea once I see the FS rail profile. Mod_Edit This comment was posted by a retailer who sells/assists sales of EZ in the UK.

Roger. Can you post or PM me a close up picture of the underside of the rail and showing how the rail clamps fit. Mod_Edit This comment was posted by a retailer who sells/assists sales of EZ in the UK.

Have you looked at these at Toolstation

The answer is yes. Mod_Edit This comment was posted by a retailer who sells/assists sales of EZ in the UK.

Just to clarify 2 points in previous responses. The EZ system has this feature too. Not sure how the Festool accomodates it, but when you change the angle of the blade on a saw it changes the the cutting point in relation to the base. With the EZ system you have 2 anti-chip edges, one on...