Molynoox's latest activity

I wanted a dog in the bench vise as well so I can hold different widths of flat stock more securely than in the tail vise I wasn't sure...

today made a good start on the bench dogs. the 19mm forstner came so I ripped some thin sections sapelle on the bandsaw, these will form...

Good question! been thinking about it. a lot! I would estimate 40hours solid work so far based since August, most of that was planing it...

OK! managed to sort that mistake out. I chopped off the end cap just enough to allow it to lever onto the dovetail. then I cut a...

managed to steal a bit more time on this. have dismantled the old thing I'd been using which served me well whilst I decided if I...

I've finished the leg frames and they have a coat of osmo polyx on them. I messed up one of the mortices (the lower taller ones) I think...

made a good start on the leg frames. I made the new legs square and coplaner ready to accept the mortices. the legs are approx 6x5"...

not much progress thanks to the mewling one but I've infilled the initial vice cutaway in favour of housing it in the apron. I did a...

so the top did this in sections so initially scrub planed the stock then refined this before using the jointer plane then glue up...

Been quiescent for a few weeks thanks to work being busy but finally have some bits for the new workbench built up. In addition the...

Hi, This is some pictures of my first ever workbench. It was my first time using planes, cutting half laps and using chisels for some...

Well the obvious thing to do would be to cover it with membrane and then battens and then clad it with tongue and groove or composite or...

Cement boards like fermacell. You can paint it to look a bit nicer.

Just seen this from Ryobi, looks quite handy for transporting toolboxes then using as a quick work surface...

Here in Bulgaria, the post - and courier services - won't take firearms. As a shooter, I find it amusing that they're quite happy to...