I changed to Tuffsaw blades recently for my Record BS350 and I can hardly believe how much better they are than the "standard" blades supplied by Record.
I used mine to frame a 24ft shed and greenhouse and to cut all the flooring and cladding as well as trim the roof shingles. It worked very well and stayed accurate throughout. Hope you get at least as much good use as I did!
Jim
Hi Bob
Thanks for this. The terminals on the "on side of the switch aren't connected to anything until the switch is thrown. I'm pretty sure that the terminals on the "off" side of the switch are connected to the coil.
If when you say the "load" you mean the planer's motor, then it's as I...
Hi Olly
Thanks for your reply. My switch looks the same as yours from the picture, but the on button is black, not green, so perhaps it's not the same after all.
The old switch made a slight hum when the power was turned on (without switching on the motor). The old switch would sort of...
I wonder if anybody can help with this problem?
I have a used Axi CT150 planer which kept shorting the mains when switched on. Eventually I bought a new switch from Axi (I suspected the old one because it was noisy) and found that the old switch had been wired with the mains coming in to the...
Hi all
Hereis my January bowl. I think it's idigbo, 230mm across, 60mm high, made with 3/8" and 1/2" Henry Taylor superflutes, finished with 240 grit and a bit of thinned cellulose sanding sealer.