UKworkshop.co.uk

Help Support UKworkshop.co.uk:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
D
Reaction score
196

Latest activity Postings About

    • D
      Dee J replied to the thread Live edge mirror question.
      You've spotted the flaw in the concept. The glue may well not be flexible enough. Careful design to isolate the glass is the way to go...
    • D
      Dee J replied to the thread Record Vice Guide Bars Bent.
      Or you could take the pragmatic approach and make a tapered wooden outer jaw to compensate...
    • D
      Dee J replied to the thread Gate construction lore ?.
      Don't know about lore, but personally I'd slant the braces more and centre them to the gate. And notch the ends of the braces into the...
    • D
      Dee J replied to the thread water proofing.
      Short answer-no, not to hold water. Some folks argue that epoxy resin might work. But really nothing is guaranteed. Better to use a...
    • D
      Dee J reacted to fatbob's post in the thread Coopers with Like Like.
      Just alternative storage for larger quantities, they had one there that held 45,000 litres, you could almost live in it!
    • D
      Dee J replied to the thread Coopers.
      Fascinating. What's the application for the tulip-shaped large barrels?
    • D
      Dee J replied to the thread Straightening a twisted frame.
      If the timbers are basically straight, but with a twist, then you can cut the joins to allow for that, so the twist doesn't transfer to...
    • D
      Dee J replied to the thread Oak veneer mdf doors.
      While agreeing that it's their fault, and ideally they should replace the whole sheet (which is what you bought), realistically that was...
    • D
      Second thread on this subject? What makes you think it's mould other than the appearance. Anyway.... Tannins? Tannic acid, naturally...
    • D
      Dee J replied to the thread Cleaning oak doors.
      Wire wool on oak? Risking black staining if any fibres/debris remains in the grain.... Perhaps Scotch-Brite would be safer. But...
    • D
      Is it old or new parquet? What was the subfloor like before filling? It seems a bit quick for mould, wondering if it's some some of...
    • D
      No it's not possible. Design around a commonly available glass or plastic container to use a a liner.
    • D
      Dee J replied to the thread Buying from EU.
      Seems to be possible https://community.hmrc.gov.uk/customerforums/ie/7b7872b1-61d2-ed11-9ac4-00155d9c773c But I suspect that the...
    • D
      It's a poor design, but not unusual for fancy-looking door furniture. You could cut tighter to the hinge pin with a bit of easing for...
    • D
      It'll work fine. But you can probably find a new motor-fan unit for your existing hood...
  • Loading…
  • Loading…
Back
Top