Dauph

If you're an experienced DIYer then yes, do it but, be prepared for it to take a while. If you are inexperienced, the (reasonably high)...

I hope I'm not adding confusion but, the method I use (from the interwebs) is that a 1 to 4 ratio is the same as a 2lb cut. So 25g...

New here. Last thing I did was a small ash shaker side table. Hand tool only build.

Practicing with router table so a couple of beach T-light holders. Then had a go at a handy little ceder pencil case.. I've got a...

Thank you. Yes. I printed it out on a piece of paper and stuck it to the wood with masking tape, then used a knife to transfer the...

Those are lovely. Did you carve the lettering by hand as well?

Yeah, I'm going to try get it all aligned properly without a coupler next. Ta

Whats wrong with a piece of reinforced rubber hose, aka heater hose,,isnt that what was always used in these situations? Steve.

I remember reading a sociology/psychology article that stated: If you put a random group of people together and tell them they need to...

I did see those but had no idea how they work. What is backlash in this situation/application? Might give it a go. Cheers

If you are still struggling after your next trial you could think about a change in design. Put a pulley on the drum shaft, put a...

I guess I'm about to find out how accurate I can be :unsure:

A single universal joint will only allow angular misalignment in one plane. In addition, in anything but a coaxial arrangement, a...

A Farmer in Yorkshire sees a bloke drinking from his stream and shouts; "Ey up cock! Tha dunt wanna be drinkin watta from theer, it's...

They look much more sturdy. I assume it'll do the same job I.E. make allowances for slight misalignment/deviation and vibration?