Recent content by cult

Refreshing up on my obtuses. The last time i cut some obtuse angles was in 2008ish. For an example, If i have an angle of 142d and i want to split down the middle for my skirting board and cornice. I get an angle of 71d, i then take away 71 from 90 which leave me with a cut of 19d on the...

I had the paneling in mind. The base units are 720 tall, so 2x720 is 1440mm plus the kicker board is 150mm that is 1590mm. That still leaves me short to be inline with the wall unit that is 1970 or 2100mm. I might just have to make the tall unit up from scratch. Its getting doors for it. This...

I havent said to her yet :oops:

Im re-arranging my kitchen and have it half installed and on one corner, i half 500deep x 700 wide because the external room opens inwards. I was going to make up a tall unit which will be 600mmx500 deep plus a packer piece. I also have 2x 500 wide base units with doors left over so i was...

i was thinking maybe that few mm difference would have thrown me out. Tank you for clearing that up. so even if it was totally sq, the jig would have still cut it normal.

the ones ive did before had more of a round on it

Here is the worktop. Didnt really want to cut it untill next weekend after i know what type it is. As said in the OP, they werent like this when ive used the kitchen jig them years ago

Looking at this new worktop i have its looking alot less nose on it than what ive been used to. The worktop is 600mm and there is a small curve at the top however this is in no was like the worktops ive cut years ago. Ive phoned a carpenter i know, and hes mentioned it might be a squared face...

When using the kitchen worktop jig and its all set up, there seems to be abit of play in the jig when the guide bush is set in place, its only a few mm but does it matter what side i run the guide bush on. Say when im cutting with the router and i run the bush on the right hand side of the...

Why does this first guy cut the kitchen worktop upside down for both male and female cuts on these 2 videos but then on the other videos, the other guy is cutting his face up. https://youtu.be/_4YyrWyOTOE https://youtu.be/YUPwiPA7g0E https://www.youtube.com/watch?v=r9itxGKPt5I Another...

The electrician must not like me because theres cables mostly where these brackets go :( I might just use the timber at back all over. What should i do if the wall is out of plumb and its noticeable at the side of the wall unit.

Installing kitchen wall units and ive came across a problem. I have a cable running up the wall where ive to screw in a wall bracket for my adjustable bracket to level up and make plumb.

Youd think they would sell them cheaper. Above, they are the most expensive option.

I have a trend jig 900 now and have a work mate that will be lending me the 1/2inch router. Have the bits already for the router.

Sorry, i didnt explain myself more in the OP. I have vast experience in construction. Its just i havent installed a full kitchen in a decade. Ive repaired them, installed base units and worktops. I would have a wide selection of tools however i was just throwing this thread out there for a...