Recent content by Cefn.

Hi all. I have a problem with the speed lever action on my Axminster Craft AC370WL. It is getting harder and harder to adjust the lever to faster and slower the lathe. I have removed the covers and cleaned out the dust and there are no obvious faults that I can see. Has anyone else had this...

Spell check strikes again!

Sorry meant deema.

Thanks Blister. Thanks Denmark. I'll have a look at this as well.

I currently have an Axminster AC370WL but would like to upgrade. I like the spec of AP406WL but I would appreciate any feedback before I take the plunge. I'm based in Oxfordshire. Ta in advance.

Hi Dalboy. Many thanks for your reply. The diagrams help a lot thanks.

Hi all. Hope this finds you well and enjoying your wood chip manufacturing. I'm still a novice turner and I'm reading up on wood turning techniques. I have come across this similar diagrams twice now (See attached photo) and would like to question why they chose to cut it as per their diagram...

Thanks for this. Very useful info. I’ll order up bits today. Regards. Cefn.

That’s useful. Thanks for your reply. Regards Cefn.

Many thanks for this. 👍

Hi again. That great. Never considered this. I’ll check bolt size and see where I can get a couple. Best wishes Cefn.

Hi all. I need to fit a nut to the bottom of a pine timber bench leg. This will be used to accept a height adjustable foot. I plan to tightly chop in the nut and glue it in place to accept the foot bolt. What glue can anyone suggest please. It needs to be strong as the bench gets moved about...

Please can I have your name and address in case i die. Just asking for the wife. 😉

Cheers Mike I guessed that might be the case, but whilst looking for ideas online, saw someone had made a pin from Spalted beech and hence the question before I went ahead. (y)