Recent content by beekeeper

Thanks for all the feedback Gentlemen - really helpful. I have a T11 on an Incra table with positioner with stops so could have a go on an incremental cut basis as suggested by Surrey Hills with the ball nose cutter 9 fingers suggested. If done incrementally and the length of cut is reduced...

Thank you gentlemen I am not familiar with the relative advantages of a Spindle moulder over a standard router table. Clearly there must be some sort of Arc cut avaiable on the Spindle moulder to give such an even plunge in and out of the cut. Would anyone know if there any way this can be...

Hello UK workshop - I am a relative newcomer to woodworking and whilst I have been a member here for a while I normally spend my time absorbing the advice from the more experienced posters to this forum. However I should be grateful if anyone could possibly advise how the bee hive handles shown...

The run down occurs while under load, but often under relatively light load. It is not what you might call a laboured motor run down due over load ie just a reduction in revs down to nil and the motor sounds normal. Just winds down then winds back up - normally, with sods law, just when you are...

Thanks Mick I have not had it to bits yet today's job. It isnt an old machine so brush wear shouldnt be an issue. But thanks for that I will have a look today. I posted to see any other of the multitude of Trend users have had similar problems and it was well known, with a similalrly known fix...

Good evening Uk Workshop - I am a relative newcomer to the delights of woodworking kit and I should be grateful if someone could offer me advice on an intermittent fault on a Trend T5 router which I have recently purchased second hand. Whilst in use the soft start motor will wind up normally...

Good evening Uk Workshop - I am a relative newcomer to the delights of woodworking kit and I should be grateful if someone could offer me advice on an intermittent fault on a Trend T5 router which I have recently purchased second hand. Whilst in use the soft start motor will wind up normally...

Good evening Uk Workshop - I am a relative newcomer to the delights of woodworking kit and I should be grateful if someone could offer me advice on an intermittent fault on a Trend T5 router which I have recently purchased second hand. Whilst in use the soft start motor will wind up normally...