Guys any idea what could be causing it to stop and start ?
https://1drv.ms/v/s!AoIHLHWc2o66baD4CxjG5sly_iA
I bought it years ago for my dad to use and after a year of him not using it I thought I'd use it. It kept starting and stopping which I put down to the unheated garage causing water inside to freeze and blowing all the seals.
I tried a softly softly disassemble and swapped the capacitor with an identical pressure washer I use for work- its 150% not a capacitor issue ;@) I cleared out my shed at the weekend and thought I'd go guns blazing at taking it apart. I was doing well until I noticed what looked like kettle scale on some of the metal components.
when I pushed the micro switch it caused these 3 piston things-
To run continuously. I started believing it could be fixed. I soaked the bits in white vinegar but nothing has changed.I don't need it but its began to niggle me again that perhaps it could be something simple. I couldn't quite figure out what causes the micro switch to become pressed- a demand of water/release from the gun ? Any ideas chaps?
Sent from my SM-G960F using Tapatalk
https://1drv.ms/v/s!AoIHLHWc2o66baD4CxjG5sly_iA
I bought it years ago for my dad to use and after a year of him not using it I thought I'd use it. It kept starting and stopping which I put down to the unheated garage causing water inside to freeze and blowing all the seals.
I tried a softly softly disassemble and swapped the capacitor with an identical pressure washer I use for work- its 150% not a capacitor issue ;@) I cleared out my shed at the weekend and thought I'd go guns blazing at taking it apart. I was doing well until I noticed what looked like kettle scale on some of the metal components.
![9b7e1807c587ddd6d6f4a5da939c7ddd.jpg](https://proxy.imagearchive.com/0f0/0f014e1110d61c1d26555f4d27e304d0.jpg)
when I pushed the micro switch it caused these 3 piston things-
![c1afe8a4ebd38b7c0241cd53561d391b.jpg](https://proxy.imagearchive.com/28f/28ffb9f0dfa123c10b1680df4e7ab447.jpg)
To run continuously. I started believing it could be fixed. I soaked the bits in white vinegar but nothing has changed.I don't need it but its began to niggle me again that perhaps it could be something simple. I couldn't quite figure out what causes the micro switch to become pressed- a demand of water/release from the gun ? Any ideas chaps?
Sent from my SM-G960F using Tapatalk