Search results

Hi there, thank you for replying, I put a square against the fence and the blade and although it starts of square, closest to me there is a gap between the blade and the square identical to the gap left on wood when i make cuts. I have adjusted the blade slightly but as there is only one hole...

Hi there, Initially I believed the saw blade was bent but after installing a brand new blade today I had the exact same problem. The cuts are not straight and as you can see from the image the wood is tight against the blade at the front but towards the back appears a few mm off and this is...

Hi there, have been having trouble with my Erbauer 10 inch SMS as when i use the sliding function when cutting it tends to produce an off-square/slightly curved cut with the end grain showing different levels as if the saw is curving..? When i cut straight down no problem whatsoever! Also the...

Hi, sorry for late reply thanks for all suggestions, i have used a hand plane and seen more than adequate results. Thanks.

Hi, would a mitre saw do the job? I have a plunge router no table.. thanks for the suggestions.

Hi there, I am wondering if anyone has advice on how i would go about cutting a 45 degree angled bevel on an edge of a 12mm thick x 32mm wide x 150mm long piece of wood. Thanks. EDIT: I am without a table saw and jigsaws tilt does not reach 45mm.