Search results

i'm an EMCO enthusiast, been using them for 45+years. This mill has the power feed table and super rare emco machine vice (opens to 110mm) You can lower the head in micros, very precise action. i ALWAYS coat all the ways and leadscrews with slideway oil prior to use. Has a MT2 spindle. Its...

hi, very interesting, can you elaborate on your system a little more pls? regards carl

hi, very interesting, can you elaborate on your system a little more pls? regards carl

Installing a upvc window into a brick opening, which exterior silicon would you use to weather seal it? There are so many at screefix!

this this is an outside hardwood window cill with a upvc window frame sat on top

i bought one of each (1ltr) cost me £70! which no dough means i will have to go around the house and do all the woodwork! on a similar note, what silicon would you use to seal a new upvc window to a brick opening? there are just so many in the screwfix catalogue

thank you, expensive but will give it a try regards carl

What would you recommend to protect a new hardwood window cill before its installed? a varnish not paint thanks carl

i made a smallish MFT a while ago and wanted to make a larger 8ft x 4ft one BUT one that came apart in two, so i spoke to Chris Smith about making one so i drew one up so he could CNC route it for me. The idea is to have rounded dovetails that interlock two 4ft sections, chris did this and when...

i had lots of 10mm holes to drill in the top of a welding table i made so i hired a mag drill. it has a magnetic base and uses special cutters that drill the hole in one go with oil fed down the middle of the cutter. i was so impressed with it i bought it and have used it many times since

How much for an 8x4 19 mm medite mr with about 200 holes?

How do you make them and out of what material

hi, it will eventually get replaced but i will be pretty careful with it so should last a log time. i have seen the parf 2 system, i'm not sure if it warrants getting one of those so will wait and see what CNC have to offer

thanks for that, no point in reinventing the wheel! just emailed them

hi, i'm building a MFT to sit on a pair of TOUGHBUILT C700 saw horses out of 19mm MDF. does anyone know a CNC company in hampshire that can machine the 20mm dog holes? cheers carl

ok, will do, thanks

yes like it makes sense

i have never used a french cleat before

i have a 20mm recess but didnt want any holes visible from the front hence a simple french cleat and rely on the weight of the rack to keep it in place

if its near the top and you pull the bottom away from the wall there is a lot of leverage to jack to cupboard up and off the cleat, if it was say half way down you would not be able to do this so easily. that is my thinking