Search results

While mucking about trying to set up the blade, I was rather annoyed with the blade guard binding. Took the blade off and operated the guard. It seemed to be sticking on the plastic lever where the metal locking catch sits between two positioning guides. The guides were a little proud, so...

There is a thread spmewhere, which I started, about the adjustment of the above for squaring up to the blade. Unfortunately I can't find it anywhere not even in my messages I'm supposed to have put up. Mind, when I try to cut and paste, everything ends up in the ether. I'm looking for a reply...

I've had my saw a few months now and am very happy with it apart from still not getting it absolutely accurate for cutting mitres to match up. I've spent a lot of time on it and gone through quite a bit of scrap wood which is even more scrappy now. However, I'll get there. What I would like to...

Hi all, I bought an Evolution Rage 5-S table saw about 18 months ago. Mainly to make picture frames. Unfortunately I do not have much success due to the inaccuracy of the mitre slide bar. I set everything up using a set square, but obviously the slackness in the mitre slide means inexact cuts. I...

Hi, Not only am I new to the forum, but also woodworking. However in my wisdom, I decided to make some tool boxes for all my other tools. I have lots of sockets, ratchets, extensions, files spanners , taps, dies, drills, etc.etc.. I decided to do this by recessing shaped holes in a board and...