Search results

Hi my lathe is a Tyme Cub and I suspect the bearings need replacing, is there anyone who can who can advise on the (How To) ?. Regards Ken

Hi I am trying to source the correct Thread Tap , are you able to point me in the right direction. Regards Ken

Hi, Searched high and low for this answer to as yet to no avail, are you able to help out with this. Regards ken

Hi I purchased a set of 4 drive centres, three of them are self explanatory but there is one, called a cup centre with no locating point that protrudes it is similar to a hole punch, will enclose photo's, it will be obvious to most of you, except me, searched the internet but as yet to no avail...

Hi I am hoping you can put me in the right direction with this, just of late the lathe constantly trips out, I do not have the knowledge to determine what the likely cause could be i.e. Brushes worn out or maybe the switch box itself, perhaps someone may have experienced this with type of lathe...

Hi are you able to point me in the right direction on sourcing the above threaded nuts, I know the Headstock spindle thread is 20mmx2mm . I need these to mount various blank holding project. Regards Ken

Hi =, have just acquired a tyme Cub wood lathe and discovered that the threaded insert to the tail stock spindle is seize solid and cannot remove I also suspect that if it is a bearing insert at the rear then that to is seized and lastly I cannot determine whether it is a RH or LH Thread I am a...