Search results

that's a real stinker,i live in highlands of scotland 15 miles from john o'groats,the item is pick up only and my van is off the road at present :( oh well, be more fun building my own :)

brilliant,cheers for that.was the foot op one i was looking for

anyone have any plans or drawings for a simply built lathe

as you can see big,just not bright enough to try it

i make do with a bench i built from a couple of pallets and vice attached any other clamping down i need is done with g clamps through the top as it is made from a half pallet so it still has gaps between the boards!

yuk...only thing appealing is the bananas :)

over the pasy few months i have collected old pine beds that people have been getting rid of,for the long lengths and slats as they are handy for building things. since we have a large dog that keeps jumping the wall i came up with this .to build the whole lot and erect it ,it only cost about...

try using a heat gun..the elecric type,it will take it down to bare wood without burning

if you have only a few cuts to do it seems a waste to go spending on more equipment to do the job.why not mark it up and take to your local woodyard and ask them to cut it for you .they probably not charge much...hope you get through it anyway................

could do with a cheaper courier service up here ,we live in Wick the price of postage on some things is just stupid.... :?

good one stevie,i have the same problem of loads of smaller tools .to have them laid out in a shallow drawer would make particular tools easier to find.you got my vote on this one.

Does anyone have plans that would turn my circular saw to saw table or know where i may get plans.Have uses for a large table but cannot afford to go and purchase an all singing and dancing one :?

Cheers for link Carlc,some good plans on the site.think i just copy pets at home one though.

does anyone know where i could get drawings for rabbit hutches.have found some on some sites but they are a bit simple,looking for the two storey type of cages

I have an idea for a new type of sanding application complete with working prototype.Has anyone out there have any ideas on who i would take this to or what my best route would be to get it on the market