Search results

Thanks to all for all your ideas and pointers - I will have a thorough look at all your suggestions Andrew

I have just purchased a Jet 1221vs as a first lathe - I used to do a fair bit of turning but not for 30 years! It does not come with a chuck - could I ask what others might recommend for a good all-rounder? any thoughts that are on the Axminster range - I am happy to spend a reasonable amount to...

are you open to offers at all? Andrew

Snipity, snip...................................................................... anyone have any thoughts as to what I might expect to get if selling/here or on ebay/.... Mod Edit: we do not encourage "valuation" posts. There's a clue in your post about researching prices- eBay. Thanks for...

Thanks all for the suggestions I'll give metabo a ring Monday and see what they say....

It's a 2 year old metabo hc260 and to be honest edges pretty well on thinner stock, but I noticed a problem recently planing a 5 inch wide piece of oak Thanks for all the suggestions I may contact metabo direct to see what a replacement out feed table comes in at, guessing it won't be covered...

having struggled for hours yesterday to adjust a new set of planer blades I placed a level edge across the width of the outfeed table - to realise that it is approx 1mm lower in the centre than at the edges Does anyone have any suggestions, other than ditching the whole machine, to remedy this...

jim - brilliant/thank you so much Andrew

dear all I'd be really grateful for any advice having picked up a draper cyclone 40130 cheap recently I have no instructions and am at a bit of a loss with the 3 filters - I have a drum filter in situ under the motor, and 6 paper bags (?where do they go!) and no cloth type filter that I have...