Search results

Having read some of the reviews re the Trend T4 router, I am now more unsure than when I started looking.. some say its great whilst other say its rubbish, basically I am looking for one that is easy to use cutting out hinges and door furniture etc, the trouble I find is seeing the cutter clearly...

I know this question will raise a few tut tuts from all those who are Gas Safe candidates, are compression joints frowned on when it comes to fittings on gas pipes, I note that generally that copper end fed joints are used, obviously cheaper, however I have a situation where I am having to join...

Can anyone help please.. I have a Tower two port valve model MV2-22C I have two fitted in my boiler system, they need a bit of lubrication once in a blue moon, sadly this time I over did it with the WD40 and it got into the micro switch unit (or washed something in to it) and the switch and the...

Can anyone please advise on a reliable kitchen work top jig that's not to expensive, looking on Ebay the prices seem so far apart for an item that is supposed to the same job, I appreciate that quality comes into the equation, but how can you really tell, until perhaps its to late! I have seen a...

Thanks to all who replied over my last question, I have had to fit a new electric motor, I found a TEC 2 pole 1.5hp 2810 RPM motor fitted ok after a slight bit of alteration , I am assuming, having looked at the required speed of the saw and planner that the drive for these is via the 40mm...

Any idea how to lubricate the bearings as the grease access points are just ball bearing holes that are usually used for oil can lubrication in the UK, my normal grease gun is no good, even pressing up hard, the grease comes out the sides of the nozzle and there is no indication if any grease...