Search results

I am building a lot more drawers lately so it could be justified...any advice would be welcome. Many thanks.

Minimum material thickness on a Trend DC400 Dovetail Centre?I like to use 5/8 as they work well with the runners I use, any advice would be great.Looking for a new jig as I'v had my fill of the CDJ300

thanks nick

Looks like a great morticer, a little on the big side for me though as I was looking for something that I could stow. Thanks

Thanks, I've been using an old draper one for ages and the fence kind of wobbled so I used to clamp it and then set the chisel square to it, ideally I was looking for a machine without a faf on but on a relatively cheap machine I will probably have to expect a little here and there. I'll defo...

JET - JWS 34LX Spindle Moulder can any one tell how to intstall the router cutter collets as I've tried to follow the manual but to no avail I presume its a left handed thread but unsure now if I tightening or loosening arghhhh!

Thinking of using some tenoning heads for a 3hp spindle moulder 30-50mm length of tenon will suffice I've seen some Whitehill Limiter Tenoning Heads, does the top and bottom edge of the cutter produce the tenon and the end of the profile the shoulder? some advice would be great. In the past...

Thanks for your reply, I ended up speaking to Axminster who informed me that different manufacturers will use the same drawings to produce the same machine and also mentioned that even in the same factory there can be varying tolerances, as you did. They assured me that if there was a...

same machine different brand/licence....I'm looking to by a bench top morticer having read the reviews for a axminster AW16BMST2 there seems to be a problem with getting the fences square, does any body know if the SIP 01944 is a different machine. Can any one recomend a similar machine 1/2h.p...

try Hafele cat no.642.59.975(750mm) or 642.56.659(650mm),642.56.800(800mm)642.56.926(1200mm)

same machine different brand/licence....I'm looking to by a bench top morticer having read the reviews for a axminster AW16BMST2 there seems to be a problem with getting the fences square, does any body know if the SIP 01944 is a different machine. Can any one recomend a similar machine...

Kendal is about 2 hours from me, the A66 is not a bad road,quite scenic in fact(when it's open as they shut it frequently in the winter!) I'll probably swing by on my travels. Many thanks Matthew

Sounds great. I think I'll make a visit to Woodford and check one out, Stockport is not too bad a journey from where I live.

Thanks Bob, I've got that one in my sights.

I'm looking to upgrade my table saw. I've been using a Metabo Magnum 1256k for the last 10 years and now I have a bit more room I want something a little more robust.(the 1256k has been great and still is). 1ph and 3hp(min) with an arbour that can except a dado set and a pre score would be ideal.

Next time I'm in town a have a look, thanks

Does anybody know a good tool/machinery supplier in the north east of England?