Quantcast
  • We invite you to join UKWorkshop.
    Members can turn off viewing Ads!

JET - JWS 34LX Spindle Moulder

UKworkshop.co.uk

Help Support UKworkshop.co.uk:

whickhamwoodwork

Established Member
Joined
11 Oct 2011
Messages
19
Reaction score
0
Location
newcastle upon tyne
JET - JWS 34LX Spindle Moulder can any one tell how to intstall the router cutter collets as I've tried to follow the manual but to no avail I presume its a left handed thread but unsure now if I tightening or loosening arghhhh!
 

Nick Laguna UK

Established Member
Joined
24 Mar 2004
Messages
261
Reaction score
40
Location
Midlands UK
Hi whickhamwoodwork - it is a left hand thread on the main spindle

The collets should screw on and just like in a router, tighten the bit up as you secure the collet to the main shaft

I'm not 100% sure if you also need the safety drawbar that screws in up from below through the main shaft?, and will check this tomorrow when I have a look at one then post back here tomorrow night

best regards
nick
Brimarc
 
Top