Recent content by Woody0

Well I clocked it up within .1mm lubricated and still the same result. Out by .3mm when I mounted the table ontop of it again. At full reach its perfect 80mm above the table. (But dangerous) But as soon as I lower it down to about 40mm or even less, it cuts more on the back of the blade then the...

Okay after some persistence, i can get it within .1mm. But its tight to wind up and down. Surely it cant be that tight to wind up or down. I should also note, that the slide that has the 3 pins applying pressure on it is made of steel. I think it should be brass. Sent from my SM-G950F using...

Thanks Tom, I've put the photos up now from my computer.

Thanks Memzey, Ive taken the table off. I see two grub screws that hold the pivot bolt hard against the female casting. Ive undone them and tapped the pivot bolt hard home. Ive put a dial indicator the body of the saw cabinet and wind the blade up and down. It still is out by 0.4mm. If I...

Hi all, Im stuck. For a while now, Ive had my wadkin 10AGS. Its never cut well. (Burning when ripping) So today I decided that I would do it properly, (align the blade to the mitre) which is fine I did that with the blade fully extended up. Between 0.01 front to back. (Metric) The issue is...