Recent content by Will123

Thanks will look at the titebond. It is a bag we have not a press.

Thanks, will do the backs first as a trial run then!

Thanks for the advice. First time that I've tried any veneering other than paper backed veneer. Thought 1.5mm would be easier to work with than say .6mm but probably wrong.

Have a project on the go that requires a 3.6metre run of 8 kitchen doors to be veneered for a horizontal grain match. I've ordered some european oak veneer leafs 1.5mm thick 3.8long that we will joint on panel saw, my question is would we be able to veneer one side of 19mm oak veneered mdf...

I have a Wilson spindle moulder with a 1 1/4 inch shaft, I would like to change it to a 30 mm shaft anyone know if this is possible?