Recent content by whevs

Hi, I needed a saw for my winter project of building a boat, I was going to make a simple table saw from an ebayyyyy Bosch circular saw but it didn't cut great and started smoking alarmingly. So I decided on a small table saw and started researching............ I ended up on here (UKWorkshop)...

Ok, I've found the blades after much searching, I have discovered that the Delta 22-562 blades are an almost identical match, only difference being that thet are 0.1mm thicker which is nothing to worry about in my opinion. I got the blades from Amazon USA and they were just under £20 including...

Thanks to all, been in touch with Appleby, very helpful but no joy as yet, those Barke knives look interesting, thanks to Cutting solutions, but I really can't figure out wether any of them would fit on the block, it's a possibility. The dimensions are: 318mm x 12mm x 1.4mm, three holes along...

Thank you all very much Mick, Tim and Eric, I'd seen Appleby on ebay but I'd forgotten to look them up, I think I was unsure if they sold anything but the mysteriously wrapped Tersa knives which I have never heard of and couldn't even see in the pics on ebay. I just checked them out and they do...

:D Hi all! I am a very enthusistic amateur woodworker with very little money, I am currently restoring a clinker built boat that has a lot of rot in it due to bodged (no offence to authentic bodgers) repairs with isopon body filler. So I borrowed a thicknesser from a mate to clean up some oak...