When reinstalling, I noticed uneven wear on one of the brush faces; maybe one wasn't seated properly? They are fiddly to get in correctly aligned due to the pressure spring
Hi All prompted by various comments (thanks) I have carried out further investigation. I opened up the motor. I’ve cleaned the contact point of the brushes on the Armature. I noted a groove or indents on the armature see pic I don’t think it’s wear but can’t be certain, might be how it was made...
Thanks for your response. The brushes were changed sometime ago because of intermittent stopping and not starting. I did check the reset button when it happened but it didn’t feel as if it clicked and it wouldn’t start again after pressing it. I don’t recall disconnecting it during the brush...
Hi All Having replaced the brushes on this hardworking bench saw I’m suspicious of the motor simply because if after unplugging and leaving it for a while re plugging it in it starts working again.
Advice required from someone technically minded as to whether I should replace the armature(?)/...
Hi everyone
I would like some advice on what sort of band saw will rip upto 75mm mainly softwood and occasionally dry oak, into straight 20mm strips please. I know about wood and construction but nothing about bandsaws! I am an occasional user and it would become one of several woodworking...
Thanks everyone. I've taken DTRs' advice and also checked out YouTube and bought the Roughneck Demolition and Lifting Bar from Toolstation. I've tryed one pallet and it seems to work quiet well. I'll report back when I've taken apart the lorry load I've been promised :!: :!:. Thanks again for...
I'm trying to establish the best way to take pallets apart with the minimum amount of damage to the wood. I'm currently experimenting with grinding nail heads off with a burr in a router although they seem to get to hot and I'm not convinced that the burr will stay sharp for any length of time...
It takes several goes to start my 4 yr old radial arm saw sometimes as many as six. Often the no load switch prevents any start. Anybody know what the problem might be please?