As the title says I'm looking for a 240v festool CMS system which is no longer sold in the UK by Festool.
Ideally with the router insert & possibly the saw insert.
Let me know what you have
Thanks
Steve
Agree with Mike
Also don't use a nail gun to fix it all together, but some 100mm hand nails of a decent gauge and it'll be a much stronger roof!
A good tip to hold the ridge in place is to cut 4 rafters and nail them to the wall plate in their final positions, two opposite each other at one...
Hi Joe
That would be fine although if it was me I'd probably use a 7" ridge so the the whole of the end of the rafter will be touching it.
You can join the ridge to make it longer using a scarf joint if required.
Cheers
Afternoon all...
Does anybody have or know somebody that has a thicknesser that can accept something that is about 670mm. Do thicknessers this wide even exist? I'm only a hobbyist so I'm not sure.
I want to make a coffee table top from a piece of live edge ash which is currently 50mm thick but...
Hi guys
Thanks for your replies so far, I assume you're talking about the blum catalogue?
I did look on their website but didn't get very far but I've just looked again and seen a tiny little link to 'catalogue' right at the bottom of the homepage so I'll have a look through that. It would help...
Hi Guys
I'm just making a built in cupboard and for the doors I want to lay 9mm mdf over 15mm mdf to create a shaker style door that'll hopefully be a bit stronger than laying 9mm over 9mm which is what I usually do and very often the doors end up bowing which is very annoying.
I usually use...
Hello all
Many thanks for all your replies to my problem with what should be such a simple task!
I'm using a 4ah dewalt cordless so its definitely not underpowered and I've tried at least 4 different cutters, 2 of which have been brand new, 1 was a forstner bit and the other was a S&J hinge...
Hello everybody,
It's time for my first post so I hope you can help.
I'm finding it very difficult to cut neat 35mm holes into 18mm MR MDF for concealed hinges on some wardrobe doors that I have made.
I'm using MR boards as that is all my local merchant now stocks.
I've tried several different...