UKworkshop.co.uk

Help Support UKworkshop.co.uk:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Steve22
Reaction score
3

Latest activity Postings About

    • Steve22
      I’ve just b a 3-16mm variable speed bench drill I got it on Tuesda. I got because I’m disabled use a wheelchair and have little strength...
    • Steve22
      Steve22 replied to the thread Myford keyless chuck.
      I’m going to try the keyed chuck first to see how I go for a few weeks if i still have problems myford said get hold of them and we will...
    • Steve22
      Steve22 reacted to Trextr7monkey's post in the thread Myford keyless chuck with Like Like.
      Yes I’m with these comments I have one on my lathe and tend to choose that over the keyed ones which I tend to leave centre drills in...
    • Steve22
      Steve22 reacted to Fergie 307's post in the thread Myford keyless chuck with Like Like.
      I would agree. They are very good used horizontally on a lathe where the bit is unlikely to just fall out. Less so, in my view anyway...
    • Steve22
      Steve22 reacted to ChaiLatte's post in the thread Myford keyless chuck with Like Like.
      To some extent a keyless chuck is self-tightening. You can insert the drill bit, and snug it up with your hand, not super tight. Then...
    • Steve22
      Steve22 reacted to peter-harrison's post in the thread Myford keyless chuck with Like Like.
      I have one of these. It's well made etc but I have a feeling that it might be harder to use than a keyed one if you have grip problems...
    • Steve22
      Steve22 reacted to ChaiLatte's post in the thread Myford keyless chuck with Like Like.
      Any Myford labelling on the chuck will be exactly that: labelling. The name is no guarantee of quality, either high or low. You could...
    • Steve22
      Steve22 reacted to clogs's post in the thread Myford keyless chuck with Like Like.
      Steve take a look at these drill's....from memory down to 5mm.. diameter they all have 3 flats ground on the shank..... I have a set for...
    • Steve22
      Steve22 replied to the thread Myford keyless chuck.
      Hi was this link for bench drill or for the drill bits that are listed ?
    • Steve22
      Steve22 replied to the thread Myford keyless chuck.
      I spoke with a guy at myFord over weekend via email and understood what i saying about my hand. He said that keyless wo be easier for me...
    • Steve22
      Steve22 replied to the thread Myford keyless chuck.
      Ok thanks v much appreciated sir
    • Steve22
      Steve22 replied to the thread Myford keyless chuck.
      I’ve attached a photo of chuck hope you might know
      • IMG_5418.png
    • Steve22
      Steve22 replied to the thread Myford keyless chuck.
      Hi you lost me on last bit I’m a novice to woodworking i took it up because I like woodworking plus it might help me after my two...
    • Steve22
      Hi all In looking at buying a 1-16mm mt2 Keyless chuck. I’ve seen a myford one and trying to find out if there any good. I’m new to...
    • Steve22
      Steve22 replied to the thread Brad point drill bit.
      Thanks guys being new is hard work and thanks for the replies and i very much appreciate your help. Now I need to try and look for...
  • Loading…
  • Loading…
Back
Top