Recent content by s.w.webb1

I've found it very helpful. I primarily bought it for one job to make a template item & then batch produce them as I needed about 40 identical. Worked a treat. As is the case in a lot of these things it's about prep time & setup. Once you have it right, it just runs. T10 is a monster of a router...

Yes, that’s probably the more likely route at this stage. The old router I had needed an upgrade anyway (adjustment and clamp wasn’t 100% reliable anymore and definitely a knack to it), the t10 is very nice, however i really was hankering after topside adjustment when i bought the table. T11 is...

Whoops! Well that was a mistaken purchase! Still a serious upgrade from what I had, but it might be going back on eBay shortly….. I mistakenly saw the adjustment screw & assumed both t10 & t11 could be adjusted from the underside Thanks for the reply!

Hi, Long time lurker, got many a bit of advice from here,know have my own question. I’ve just bought a crt mk3 table, to pair it with a t10 router. On assembly, I can’t work out if this has fine adjustment from the table side or not. Can anyone advise and if so, direct me to instructions for...