Picking up on Alf's point about the Axminster WV1000, I have a Record RSDE3 which looks similar. It copes will with the output from my 10" P/T. It leaves a few stray shavings on the floor & table, but the work is clear and that's what's important. It also has the filtration to cope with fine...
Thanks for your comments.
I have asked some questions of APTC and I thought that you might be interested to see their response
1. Can the water bath be removed or drained via a hole & plug? Or would I have to tip the machine?
This machine has a drain plug, so this makes life easier for...
Hi
I am thinking of the Axminster vertical wetstone grinder (http://www.axminster.co.uk/recno/7/product-Axminster-Universal-Vertical-Wetstone-Grinder-21264.htm) as it is cheaper than the Tormek or Scheppach Tiger grinders.
Is it (or the similar looking Delta 23-700) any good? The stone is 220...
I have a Scheppach HMS260ci with a HTC mobile base.
Generally I'm very pleased with the ease of operation and the finish. Fence is good but could be a little stiffer. Shame you have to wind the table right down to change modes but it's no big deal (and I guess that's not unusual).
With...
Problem solved.
Thanks to Philly for one of his suggestions which I have modified. Instead of sawdust, I stuck a small shim from scrap under one of the leading corners with some hot melt glue. I set the shim thickness to approx half the total twist and bingo!
I discovered another approach...
Hi everyone.
I have some twisted planks to plane on my P/T.
If I apply pressure to the plank on the infeed table, transferring to the outfeed side as soon as there is enough timber there to press on, then the face of the plank will be set by the angle of twist at that end. By the time the far...