Recent content by Ralph

Well, I tried two saw sets. One like the one in the picture above, (the pliers type) and one eclipse #77. The one pictured ended up bent and unusable. The eclipse wouldn't even scratch the surface. So I went back to the hammer. Whacked it as hard as I could. Gotta tiny bit of set. Didn't even...

Thanks guys. I'm getting a saw setting tool today. I'll let you know how it goes. Thanks again.

I think I'll try that saw setting tool. I was told they wouldnt work on big saws, but it's worth a try. The teeth file fine. They just dont like being bent.

Well, I tried it in some green ash and it was hopeless. Cut about half and inch and just stuck there. Think I'll try just a tiny bit of set. See if I can make then bend just a little. Probably end up with more snapped teeth.

Yes, Ive seen that video. And I'm doing what he does but they don't move! It's frustrating to say the least.

Hi. I'm really struggling here. I've got one of those spear and Jackson vintage crosscut saws. It's about 36 inches long and its a great american tooth pattern. I've cleaned all the rust off it and sharpened it. Problem is, it's got absolutely no set. Nothing at all. I've tried hammering them...