Search results

UKworkshop.co.uk

Help Support UKworkshop.co.uk:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. R

    Setting crosscut saw

    Well, I tried two saw sets. One like the one in the picture above, (the pliers type) and one eclipse #77. The one pictured ended up bent and unusable. The eclipse wouldn't even scratch the surface. So I went back to the hammer. Whacked it as hard as I could. Gotta tiny bit of set. Didn't even...
  2. R

    Setting crosscut saw

    Thanks guys. I'm getting a saw setting tool today. I'll let you know how it goes. Thanks again.
  3. R

    Setting crosscut saw

    I think I'll try that saw setting tool. I was told they wouldnt work on big saws, but it's worth a try. The teeth file fine. They just dont like being bent.
  4. R

    Setting crosscut saw

    Well, I tried it in some green ash and it was hopeless. Cut about half and inch and just stuck there. Think I'll try just a tiny bit of set. See if I can make then bend just a little. Probably end up with more snapped teeth.
  5. R

    Setting crosscut saw

    Yes, Ive seen that video. And I'm doing what he does but they don't move! It's frustrating to say the least.
  6. R

    Setting crosscut saw

    Hi. I'm really struggling here. I've got one of those spear and Jackson vintage crosscut saws. It's about 36 inches long and its a great american tooth pattern. I've cleaned all the rust off it and sharpened it. Problem is, it's got absolutely no set. Nothing at all. I've tried hammering them...
Back
Top