Recent content by mattjdnv

Like @Robbo3, I recommend using a small Thein type separator with a vacuum. I did have a Thein Baffle and "upgraded" it to a Top Hat design. It wasn't too hard to build and the only fiddly bit was heating and shaping the PVC pipes to get a square section on the inlet and a bell mouth on the...

Thanks!

Hi, I recently upgraded my lathe from an Axminster AW305WL to a Coronet Herald. The Axminster has a 1" x 8TPI spindle and the Herald has a M33 x 3.5mm spindle. I have a couple of Nova G3 chucks with inserts that fit the 1" x 8TPI spindle. I picked up a "Record Power Thread Adaptor M33 Female to...

I found that plastic pipe and hotglue works for tool storage. chuck jaws, sandpaper etc ended up on a shelf.