Hello, i am trying to find a 1/2" shank keyhoe router bit but my searches on the web are only coming up with 1/4" or some very cheap ones with bad reviews.
Does anyone know of or could recomend where to get one please? or are they not available?
Any help greatly appreciated thanks.
Have done some research on the +/- rake on blades, found it very interesting and learnt a lot thanks again.
One thing i noticed though is how many companies out there are selling 15degree positive rake as good for mitre saw, after reading about it i dont know how they can get away with it!
Thanks again Doug your advice is much appreciated, i had not heard of +/- hook on blades before so its good to know, i also have not seen this described in the sales blurb when looking to purchase a blade so will do some more research.
Thanks again.
On a side note can anyone see a problem with me using the 250mm 2.1kerf 40T blade on my mitre saw instead?
The saw has the same bore but requires a 254mm blade, would this be ok to use in anyones opinion?
Thanks Doug that is how i understood it also, i was just wandering if i could get away with the .2mm difference over or if anyone had tried, but on reflection i dont think it is worth the risk and have anwsered my own question.
Thanks for your help.
Hi, I have just got myself a new blade for my Dewalt DW 745 and it is a thin kerf 2.1mm
The supplied riving knife is 2.3mm
Is this safe to use? I can see that it will be very close but is this within tolerances?
Any help on this would be appreciated.
Thanks.
Thanks that sounds interesting i thought the only reason for the front fence was just to hold the sled toghether, would be interested in a link to the video if you get the time please.