Thanks JFC - that makes a lot of sense. The saw is a Ryobi ETS-1525 (the one with the riving knife alignment problem back on 03/11/05; saw replaced now and all properly aligned).
Hi
I'm about to start my first project with my new (and first) tablesaw - a very simple cabinet. I'm going to use pineboard. What is the correct, safe way to cross cut this? For instance I need to cut a piece 770x475 from a 850x495 board. From some online reading (and from the 'manual' that...
Thank you for all your replies.
Upon closer inspection, the knife is actually out of alignment at the clamping point. I found a number for Ryobi UK Tech Support and spoke to a very helpful guy there. We have decided that the best course of action is to get the whole machine swapped (no doubt...
Hi
I have just bought my first table saw - a Ryobi ETS-1525. I have started setting it up and have a question regarding the riving knife: should it be perfectly aligned with the blade? Mine is very slightly off to the right. Not a huge amount - probably less than 1mm - but visible to the...