Thanks Mikebart. I too recall seeing a thread about a related problem, but I think it related to sourcing the sprockets not the tensioning bracket. I don't recall seeing a spring when I took the assembly apart, but I guess one could be rigged up. Might be better than moving the bracket.
Thanks Bingy Man. Could you clarify what's to be hammered? The bracket shown in the pic is certainly removable but it does not appear to be deformed. As at present mounted the chain prevents closing the gap I've labelled. An alternative might be to drill a fresh hole in the frame to...
Can anyone help. I recently replaced the chain sprockets on the underside of the table, as all were worn or broken. On reassembling I found a gap between the tensioner bracket and the frame with the chain fully tightened (see pic). I suppose I could insert a spacer, but it would have to be...
Evening all. Re the plate adjustment chain tensioning system. I've recently replaced the four sprockets attached to the acme screws that adjust the plate, mentioned in the above. In doing so I removed the bracket on which the tensioner sprocket is mounted. When I tried to replace bracket...
Can anyone help
My scheppach table saw motor cut out during a job and I can't restart it. It does not respond to pressing the restart button, which goes in without resistance when pressed. There's no smell of overheating. I've checked the plug fuse and the wall socket - both OK.
Suggestions...