Anyone else using Finsa Superpan sheets for their units? I'm having awful bother with board tension this past 12 months. Now I have to rough cut to 5mm oversize and then cut a straight edge and then cut to final sizes. I'm cutting on a 3.2m Sicar panel saw.
Does anyone have a decent set of instructions of how to make drawers and install slides for the blum tandem concealed slides? I find the website hard to navigate and find simple information.
I was planning on spending around 15k for a fully automated machine with premilling and buffers but the price of this on is too good to pass up.....2k, it's in very good condition.
Hi,
I am currently considering buying a second hand Minimax ME20 Hot Melt edge bander. Does anyone know what sort of money they are worth? Going to view one tomorrow.
I'm wondering if I extend my outfeed table would it help?
I recently noticed the sliding table was about 1.5mm higher than the cast iron bed of the saw and I adjusted it so it's JUST a fraction of a millimetre higher than the bed, it helped a bit but still not great.
It's mainly used in joineries or large scale workshops that make units/kitchens made out of MFC (Melamine Faced Chipboard) which is why they have two blades, main cutting blade for cutting through and scoring/scribing blade for cutting 2-3mm off the laminate first so it doesn't tear out.
Hope...