I have 8 old internal doors to prep/paint. What do I need for a basic spray paint setup? I have a 9 cfm/25 litre compressor.
Basically something half decent for occasional use.
Thanks
Well used 2000w mitre saw, I've built a fair few things with this!
It works fine, however the blade stop isn't working properly and I cant get the blade off.
Might be a quick fix, but haven't got time to look.
Free to a good home.
Collection near Thirsk, North Yorkshire.
Lightly used planer thicknesser. Probably had less than 10 hours use, however now I've got a larger planer thicknesser this is not used anymore.
It hasn't been used for a couple of years, and will need the knives resharpening or replacing at a minimum and a good clean.
Comes with extraction...
Hmm, as I said lots of opinions :)
Good point about trying a cheaper option and a bench grinder and see how I get in.
One thing I forgot to mention is I picked up a used spindle moulder and have a lot of tooling with it so would be looking to sharpen the cutters as well.
Thanks for all the...
Quick update....
So I ended up with a Axminster TS216 table saw with sliding carriage and their 250mm P/T and got a Axminster trade Spindle Moulder off a member here with a load of tooling (that I haven't a clue about) plus an Axminster AX53E dust extractor.
Thoughts....dust extractors are...
What I want is sharp chisels so I'm not swearing when I slip and mess up a rebate!
I'm lucky that I can afford something like a Tormek but is it overkill for sharpening some blunt bevel edge chisels?
Okay so read through a lot of posts on here and everyone seems to have a different opinion.
My needs are chisel sharpening only and something that is quick to use and fairly foolproof.
I can spend up to £500 and was looking at the Tormek T4. Oh and I know nothing about sharpening chisels!