You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser.
Help Support UKworkshop.co.uk:
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
-
-
D
i bought some record machines 18 months ago and only now getting round to setting them up.
i'm left with a black round bar around 10mm...
-
D
Dowsing is easy and I’ve found water pipes with ease in the past, just keep walking across the pipe and mark the position, start at the...
-
D
came off easy enough after the oil got to work.
tried a light tap on the chuck key and away it went.
all good and thanks to one and all...
-
D
studding connector sounds good .i ve soaked it with wd40 and will keep doing so for a few days .chuck not even working to get the...
-
D
The shaft-locking idea by embedding the blade teeth is good.
The 'hit the chuck key' idea is a little cruel. As above, a big allen key...
-
D
thanks for the info.didn't want to damage the motor and as i'll not be using the chuck at any point,i did think about just cutting it...
-
D
It is just a simple thread inside the motor spindle that accepts a threaded stub on the back of the chuck. No locking. The thread is...
-
D
I don't believe these have a screw inside the chuck that locks the chuck in place once screwed onto the motor as you get with cordless...
-
D
i bought a saw 2nd hand a while back and only getting round to tidying it up now.
its been sitting idle for some time by the look of it...
-
Loading…
-
Loading…