Recent content by cyberheater

Thanks.

Which one?

I've got a pallet lying about. I wonder what I could make from it.

I've added my own fence and side bits. The fence is a lot better then the rubbish that came with it.

Thanks folks. Lots of good suggestions. I'll keep the larger pieces and turn them into something and burn the smaller bits.

I'm quite new to woodworking but I'm slowly collecting a mountain of offcuts that I've been keeping in big plastic buckets on the off chance that I might need that little bit. The end result is that I'm incrementally filling up my garage (my workshop) with loads of this stuff. What do you...

I bought a cheap table saw off gumtree recently and I noticed that the blade was not parallel to the mitre slots. I discovered there was 4 big hex bolts holding the motor assembly to the table. I relaxed those bolts and got the blade aligned to the mitre slot and then tightened them up. It...

I'm a huge fan of recycling. The reason why I choose this saw was because it had a 2k motor which is quite powerful. More then enough for me. This is it stripped down and the table levelled which involved undoing the screws that held the top to the base and adjusting the fit before...

Mine had three issues and here is how I addressed it. 1. The blade was not parallel to the mitre slot. I think the back of the blade was 2mm close to the mitre slot then the front. I was pretty disappointed to find that out. Anyway I realised that there was 4 big allen bolts holding the...

Bought a cheap table saw on Gumtree which is the same model as this: Got it home (in the pouring rain) and put it on my bench in my garage to check alignment after checking some youtube vids on how to do that. 1. Is it sitting at 90 degrees. Nope. 2. Is the blade parallel to the mitre...

You can make a decent table saw from a circular saw which works quite well.

That's a brilliant idea. I wished I'd thought of that.

The desk installed. It's massive.

As someone new to wood working this his inspiring stuff.

er... That's a good point which I hadn't thought off. :oops: I was hoping that the would has been holding my roof up for the last 60 years so would be pretty stable. May not. #-o