Recent content by Chidge10

Thanks for your reply. I will give it a go. I did think it was something like that, but the chain is very near/touching the drive shaft of the cutter head which I though looked a bit dodgy. I will give it a go though. Cheers.

Hi Julian. I'm up in Parracombe near Lynton and Lynmouth. As mentioned I'm hoping to set up a small workshop and work locally. fingers crossed etc.

Hello everyone. I recently bought a Startrite SD300 planer thicknesser that had the drive chain and the drive cog missing. Whilst I have managed to get replacement parts I cannot figure out the drive chain path/configuration. The new chain I have is an endless loop which I assume has been...

Hi everyone. What a great site this is and I am so happy I stumbled upon it and everyone's great tips and advice. I have recently relocated from just outside West London where I was working in the film industry to North Devon where I am planning on setting up a, (very) small workshop and working...