Bensox

Personally, I think it's worth going for cement board - much, much stronger than plasterboard. I use STS NoMorePly for floor and walls...

Yeah, I used a chisel to finish. I also got the edges/outline pretty good with a sharp knife before doing the routing too. I'll see if I...

Most people mark out a bow tie….hogg out the centre with a router fitted with a straight bit, then finish off with a chisel - myself...

I got a full bench-sized Rhino cutting mat - as a worktop protector, as I use craft knives a lot. I'm sure it would last a long time...

Some really great ideas and tips - especially the clock!

Very nice, thanks for sharing. I'm going read up on how those joints are done - I've used a hoffman router but that leaves rounded off...

Hi and welcome to our sanatorium 🤣 You could opt for a. Phase inverter, single to 3 phase inverter. Depending on power needed, but up...

Welcome to the forum 🤗🤗

If doing on a budget, consider adding some thin ceiling joists (2 x 1" should be stiff enough), insulation between them, held up with...

Lovely big piece - must be from an old tree as boxwood is so slow growing. Its super fine grain and hardness makes it excellent for...

Following with interest, thanks for all the photos. If you do need an extra flooring layer I can recommend concrete board - I've used...

I've seen internal stables built using that method - maybe router out railway sleepers for the uprights? I've just laid a concrete pad -...

Hello from South Yorkshire Been enjoying browsing this forum and glad to see its very active and growing fast. Thanks for letting me...